Ubc280xlt Uniden Bearcat Manual

I have a Uniden model that is not listed at the site, but I called them and still got the manual for free. Harryc-'Richard Martin' wrote in message. Can anyone help me with a copy of the manual for a Bearcat 220 or suggest where i can get one the Uniden site doesnt have that model Regards R. Specific questions on these scanners can be directed to the Uniden forum at Radioreference; be sure to look at the articles first. For software recommendations, USB cables, operating tricks and tips, see the appropriate section in the scanner's article or our Programming Your Uniden Scanner article.

November 8th 06, 12:42 AMposted to rec.radio.scanner
external usenet poster
Posts: 8
uniden bearcat BC55xlt users guide

wrote in message
oups.com...
This is an older model handfeld scanner that was given to me it works
but there is no owners/users guide with it does any one know how to
program it or know where i can find a copy of the users guide?

I don't recall where I found this, but from my archives:
Uniden Bearcat 55XLT Information
The radio is a basic 10 channel scanner. Nothing fancy. If you
disconnect wall power and it doesn't have batteries in it, it will
lose its memories.
It uses 5AA batteries. If you put NiCd's in it, you can flip a switch
in the battery compartment and they will charge when you plug it in.
(If you use an external charger you don't have to the flip the switch.
Leave it on Alkaline.)
The keypad switch 'locks' the keypad so you don't accidentally press a
button and change your settings.
To program:
Turn on radio.
It will be in scan mode. Press Manual (orange button) to stop scanning.
Press Manual button to step through channels to get to the one you want.
(Or press channel number and then manual button)
If 'LockOut' is displayed it means this channel isn't being 'Scanned.'
You will want to lock out the NWS WX (National Weather Service/Weather)
frequency. Pressing Lockout will toggle the status.
To program:
Select channel. Use keypad to enter frequency. Use 'E' for Enter
key. If the radio displays an E this means Error. Usually, the
frequency you typed in is outside of the capabilities of the scanner.
Once you hit the E you will immediately start hearing anything that's
out there on the frequency you entered.
Push the 'Review' button and the scanner will display the frequency
that is programmed for the channel. A '-' will be displayed for the
decimal point.

Civilian & Military Aircraft Frequencies
To receive civilian aircraft transmissions you will need a scanner that has a frequency range of 108-137Mhz. If you want to listen to military aircraft transmissions then you will need a scanner that has a frequency range of 225-400MHz. You should also set the scanner to the AM mode (Amplitude Modulation).
Civilian aircraft band (VHF) - 108-137MHz AM.
Military aircraft band (UHF) - 225-400MHz AM.

Search and Scan
When using a scanner you can either use the 'Search' mode where it searches through a range of frequencies until it stops when it finds a transmission for you to listen to, or use the 'Scan' mode where you store specific frequencies into the scanner and it will just scan through these frequencies until it finds a transmission.

Modes
A scanner usually lets you set either AM (Amplitude Modulation) or FM (Frequency Modulation). The scanner may also have NFM (Narrow FM) and WFM (Wide FM) but for listening to aircraft transmissions you should only use the AM mode.

Ubc280xlt Uniden Bearcat Manual Charger

Banks and Channels
The Scanner's memory is used to store your frequencies which are usually arranged into Banks and Channels. A Bank consists of a group of Channels and you can program a frequency into a Channel. The idea is that you could fill a Bank with specific frequencies for a particular airshow and just scan the Channels in that Bank. You could use other Banks to store Display Teams and/or Common Display Frequencies (used at many airshows). This helps to organise all the frequencies that you want to store on the scanner. Note that all scanners work slightly differently and you should always consult the manual for your particular model.

Step Size
The Step size will depend on the scanner and some can scan through a list of frequencies using the following steps:- 5, 6.25, 8.33, 10, 12.5, 15, 20, 25, 50, 100kHz. Using the correct Step size will mean that you don't miss any frequencies. Recently the spacing between airband frequencies has been reduced from 25KHz spacing to 8.33KHz spacing so as to increase the number of frequencies available. Therefore your airband scanner should have a step size of 8.33KHz.

Squelch
There should be a knob on your scanner to control the Squelch. When you start to search or scan then you should turn the Squelch down just enough to get rid of the background noise so that the scanner can scan through all the channels. If you leave the Squelch turned up then you will hear the background noise and the scanner will stop on that channel and will not scan.

Scanner Range
Both VHF and UHF are short range, line-of-sight radio transmissions which are restricted to a maximum range of about 200 miles due to the curvature of the earth and usually considerably less depending on the surroundings (hills etc). This means you should easily pick up transmissions from an aircraft in the air as there are no obstructions between you and the aircraft, but you may not hear the control tower of a nearby airport because there are obstructions such as hills and buildings etc. If you want to hear the control tower as well as the aircraft then you should visit the airport.

UK Airshows
People usually use scanners at UK airshows to listen in on the control tower and the pilots so that they know what is happening and when the aircraft are about to display. It is a good idea to be discreet with your scanner and use earphones so that you don't draw attention to yourself or disturb other people at the show. The frequencies used at UK Airshows are usually in the civilian frequency range of 108-137Mhz but if you wanted to listen in on the Red Arrows leader barking out his commands then you will need a scanner capable of listen to military aircraft transmissions in the range of 225-400MHz. If you are going to an airshow outside of the UK then check out their laws regarding airband scanners and if you are not sure then do not take your scanner with you.

Bearcat

Trackers
You can also track an aircraft on your computer or smartphone while using your scanner to listen in. A tracker will display the aircraft on a map and supply lots of information such as aircraft type, airline, where it took off, its destination, altitude and speed. Below are a few trackers (civilian & Military aircraft):
Flight Radar 24.
Plane Finder.
ADS-B Exchange / Global Radar View (military).
Plane Finder Free App (Android).
Plane Finder Free App (IOS).

Uniden Bearcat Manual Frequencies

Airband Frequencies
A list of scanner frequencies can be found on this website for UK airports, UK airshows, display teams and Royal Air Force bases.
UK Airport Scanner Frequencies.
Airshow Scanner Frequencies.
Display Teams Scanner Frequencies.
Royal Air Force Scanner Frequencies.

Ubc280xlt Uniden Bearcat Manual Bc60xlt

Ubc280xlt Uniden Bearcat Manual

Ubc280xlt Uniden Bearcat Manual Download

Useful Links
Airband Scanners.
UK Airports (Trackers, Frequencies, arrivals etc).
UK Military Bases (Trackers, Frequencies, aircraft etc).
Live Aviation.
More Airband Scanner Reviews.